NOT AVAILABLE
Obadiah's custom built Heat Shield for The Esse Ironheart Cookstove
None of our heat shields are UL listed or tested. To do so would make the cost prohibitive. They are designed using a engineering principle that says a one
inch ventilated air space between layers, equals a 66% reduction in
Clearances to Combustibles, called a "K Factor".
This is an approved NFPA formula and is widely used in commercial,
industrial and architectural applications by engineers and architects in
various applications where protection from radiant heat is necessary.
(For example, a KQ stove requires a 36" clearance to combustibles,
our heat shield would reduce that down to 10 1/4" with double wall
chimney)
8" Double Wall Black Chimney, 18" Single Wall Black Chimney clearance to combustibles.
Click Here for the National Fire Protection Association's (NFPA 211-26) for info on how to reduce clearances
Note: Putting brick or masonry over a combustible
wall without a 1" airspace, will actually make the spontaneous
combustion issue worse as the masonry will absorb the heat from the
stove and transfer it into the wall cavity.
This can take many years, but eventually the wood in the wall will dry out to a point where Spontaneous Combustion can occur.
It takes three things to make combustion (Fire).
1. Fuel (wood inside your wall)
2. Heat (your stove)
3. Oxygen (a hole in the wall to feed wire or plumbing through)
If you deny any one of these, combustion cannot occur.
The way our heat shield works is by removing the heat transfer part of the equation.
We have tested our heat shields and they allow less than 5% heat transfer through them when properly installed. They also transfer wasted radiant energy that would normally be
trapped in the wall behind the stove, into more efficient Convection
Heating.
We have measured a 30% increase in the Kitchen Queen's convection ability with our heat shield installed.
This translates into a cooler kitchen and warmer back rooms
furthest away from the stove, than you would experience without the heat
shield.
Radiant heat equates - the closer you get the hotter it gets.
Convection heat is more natural and comfortable using the laws of Thermodynamics, (heat goes up, cool goes down). Our shields pull the cool air from the floor and use it to cool the
heat shield and absorb the heat from the rear of the stove as the air
travels up through the heat shield.
This warm air is then naturally convected into the air flow in your home. A good example of how this works is to light a wood match and blow
it out, watch the smoke from the match as it begins to travel in the
natural convection zones in your home.
Heat shield for the ESSE Ironheart 
