The Napoleon NCPF110 is a hot air multi fuel furnace that can burn corn, wheat or pellets, and give you an environmentally friendly source of energy to heat you home or commercial building with (up to 3,600 sq. ft.).
There are many great features in this biomass furnace that work together to result in a product with excellent heating capability. As you can see from the graph above, these renewable sources of energy that the hot air furnace utilizes to burn cost less than non eco-friendly alternatives, such as oil and gas. You can purchase an optional wall thermostat with this unit that can control the fuel feed system to provide a constant temperature. If the clean-burning furnace gets low on fuel, the controller flashes and a buzzer sounds off to inform you that it is time to refuel. This corn burning furnace uses a natural venting system with a slower exhaust, instead of using an inefficient power venting system. For complete burning and maximum heat transfer, the combustion blower supplies a precise amount of air to the burner so that efficiency is maximized. The top loading fuel feed system keeps the burn pot and fuel storage separate, so that the risk for burn back is eliminated.
With this clean and efficient biomass heating system, you can heat your commercial or residential building in an environmentally friendly manner, while also saving some money with the cheaper fuel that you have to buy.
Heating Capacity Up to 118,000 BTU’s (up to 3600 sq.ft.)**
Furnace Efficiency 80%
Hopper Capacity - 8 bushels (10 cu. ft. ) 8 bags of corn (448 lbs), 10 bags of pellets (400 lbs)*, 8 bags of wheat (444 lbs)
Fuel Rate 2 - 15 lbs / hr*
Working Voltage 220 Volt, 15 Amp
Flue Pipe 6” diameter (15 cm)
Venting Options Class “A”, “L” vent or masonry chimney with stainless steel liner
Flue gas temp @ 20” above furnace outlet 266 – 392ºF, (130 - 200ºC) depending on the run mode
Running Modes First fire: Starting the burn pot, Low mode: Low heat (Spring & Fall), High mode: High heat (Winter), Idle mode: Keep core fire burning for automatic thermostatic control
Combustion Air Blower 150 cfm (255 m3 / hr)
Plenum Opening For Hot Air Outlet 18” x 14” (457 x 356 mm)
Return Air Opening 18” x 14” (457 x 356 mm) Designed to accept standard furnace fi lter block
Burn Pot 310 Stainless steel (9 GA), double walled with dual combustion air induction inlets
Heat Exchanger Steel boiler plate, heavy duty tubes
Auger Motor High torque, fan cooled (3/4 hp)
Forced Air Blower 1800 cfm (3060 m3 / hr)
Dimensions (Height x Width x Depth) 51” x 52” x 57”
Weight (Furnace And Hopper) 770 lbs approx (350 kg)
Weight (Furnace Only) 560 lbs (255 kg)
Shovel Adds fuel to the burn pot for initial start up
Scraper Exhaust housing scraper
Wire Brush Heat exchanger brush
* Depending on quality and moisture content of fuel used.
** Figures may vary with individual conditions such as fl oor plan layout, insulation value/heat loss of the home, geographical location and the fuel used.
|