|
|
|
|
The Glenwood Heaters Econo Flame 7510 is a waste oil boiler that gives you a way to burn your waste oils in a clean, environmentally friendly way, while giving you tens of thousands of BTUs to heat any large building (up to 3,000 square feet).
There are a large variety of waste oils that you can burn in this environmentally friendly waste oil boiler. You can properly dispose of the following oils by burning them in this waste oil heater: cooking oils, motor oils (up to SAE 50), hydraulic fluids, transmission fluids and heating oils. With 1/4" A36 steel plates, this rugged boiler has superior heat efficiency thanks to a fire tube type heat exchanger with spiral baffles that emit the available heat into the water jacket. The frequency with which you have to clean this waste oil burning boiler is reduced by 4 inch tubes that handle the higher residue that comes from burning such oils.
Click here for Single Line PEX Pipe
Click here for Dual Line PEX Pipe
Whether you need to heat a residential, commercial, or agricultural building, there is an Econo Flame high efficiency waste oil boiler model that can satisfy your heating needs. Plus, while providing heat, you help the environment by disposing these materials properly in a manner that emits no visible emissions.
20 YEAR NON PRO RATED
WARRANTY
When you purchase heating equipment
manufactured by Glenwood Heaters, LLC, you, the original owner, receive a
twenty (20) year warranty against rust through or failed welds.
The obligation of Glenwood Heaters, LLC is
limited to exchanging or replacing defective parts with new or remanufactured
parts at the option of Glenwood Heaters, LLC, or repairing the defective
part.
Said decision as to which option
should be exercised to be at the sole discretion of Glenwood Heaters, LLC. You
will be responsible for paying the cost of shipping and handling.
This warranty and the provisions
contained hereunder are extended only to the original owner, and do not
transfer to subsequent owners of heating equipment manufactured by Glenwood Heaters,
LLC.
This warranty is void as to any
part of the heating equipment which has been damaged by owner or any other
individual once the equipment is in possession of the owner.
This warranty is void whether damage was
caused by misuse, accident, negligence in operation or maintenance, improper
self-help attempt to repair, etc.
Additionally, this warranty does
not extend to the product unless the product was installed pursuant to the
installation procedure outlined in the owner's manual.
The warranty on all other parts of the
heating equipment expires one (1) year from the date of purchase of the product
by the original owner, but this warranty does not apply or extend to any
specific parts excluded from coverage below.
This warranty is in lieu of all
other warranties, express or implied, including the warranty of merchantability
an all other obligations and liability of Glenwood Heater, LLC.
Glenwood Heaters, LLC neither assumes not
authorizes any person to assume for Glenwood Heaters, LLC any other liability
in connection with sales or installation of the heating equipment.
EXCLUSIONS: THIS WARRANTY DOES NOT APPLY OR EXTEND TO THE PAINT, THE
GRATES, AND THE HEAT EXCHANGER.
This warranty does not cover
service calls that are related to the problems caused by faulty installation,
misuse or to change the original set-up of the product.
The warranty does not cover unauthorized
modifications of the product nor does it cover service call to replace or
repair any portion of the heating system unless that part of the heating system
has shown to be defective under normal recommended maintenance and use of the
heating equipment.
Specifications | Econo Flame 7510 Waste Oil Boiler | Dimensions (W X L X H) | 24” X 84” X 24” | Water Capacity (Gal.) | 25 | BTU Output | 100,000 | Will Heat* (sq. ft,) | 3,000 | Fitting Size (inches) | 1.5 | Flue Size (inches) | 8 | Approximate Weight (lbs) | 800 |
*Building and climate conditions will affect heating capacity.
Resources:
Manual Brochure Burner Manual
BTU Values
Fuel
|
BTU's
|
Unit of Measurement
|
Wood Shavings/Sawdust
|
2,000,000
16,000,000
|
Cubic Yard
Ton
|
Wood Chips
|
12,000,000
|
Ton
|
Wood Pellets
|
16,000,000
|
Ton
|
Coal
|
26,000,000
|
Ton
|
Rubber
|
32,000,000
|
Ton
|
Liquid Propane
|
92,000
|
Gallon
|
Heating Oil
|
139,000
|
Gallon
|
Waste Oil
|
190,000
|
Gallon
|
Diesel Exhaust
|
1800
|
Horsepower
|
Glenwood Econo Flame 7520 Waste Oil Burner - Part 1: Using the Burner Glenwood Econo Flame 7520 Waste Oil Burner - Part 2: Cleaning the Boiler Glenwood Econo Flame 7520 Waste Oil Burner - Part 3: Construction & Installation Tips Glenwood Econo Flame 7520 Waste Oil Burner - Part 4: The Pump Tank
|
|
|
|
|
|
|
|
|
|
|
|
|
Features
Burns
|
Heats
|
Cooking Oils
|
Shops and Warehouses
|
Motor Oils (Up to SAE 50)
|
Greenhouses
|
Hydraulic Fluids
|
Livestock Confinement Buildings
|
Transmission Fluids
|
Make-Up Air
|
Heating Oil
|
Kilns & More!
|
1. Tough powder coat finish.
2. Insulated swing out burner door provides access to the nozzle, retention head, and electrodes for easy servicing. Also provides easy access to the combustion chamber for cleaning.
4. High efficiency heat exchanger with aggressive spiral baffles transfers all the available heat into the water jacket. The baffles can be easily removed for cleaning.
5. 4 inch tubes handle the higher residue that from burning waste oil, helping to reduce cleaning frequencies.
3. Swing out door allows easy access to the heat exchanger for cleaning.
6. The spend combustion gases enter the stove pipe through the water jacket for increased heat extraction.
|
|
|
|
|
|
|